Long time not to use 3dmax .
In my memory , I studied it at least 10 years ago , at that time , I studied 3DS 4.0 in 386 computer , added a IC for float computering , named as 387 , then in about 1999 , I used 3DMAX 2.5 in MMX166 computer , then was familar with 3DMAX 3.1 ….. At that moment , I did not graduate yet .
One of my leg was in 3D design field already but when i practiced in an 3D design company in the 1st month, it is very hard working , no development and extreme low salary , but boss and manager earned 100 times more than ours … but we were working like going to die . At that moment , I had thought that I can try other design company , but they were almost the same , more over , they needed hand drawing ! But I was not good at this . (the company used Pentium 400 only )
So I have to go . God save me because I major in foreign trade in university , so that at last I ran out of 3D design , worked in Export field for 10 years .
Today , I meet 3D designer in our spa design company , their design is so good , my interest in 3d design does not lose yet , so i re-install 3DMAX 2010 in our fast, 2.3G AMD Quad-core processor 32bit Win7 , and play 3DMAX for a while .
Although there are lots of new module like VRAY 1.5 , Fur , but the base system of 3DMAX is almost the same , so i can remember fast . ( I was expert in 3DMAX 🙂
Create first model in Nurbs method , please check :
3DMAX2010 has so many control data , it is hard to make it looks like reality , and I don’t think my job is 3D design again , I just hope to use it whenever necessary .
I would rather learn Solidwork later , that is more practical .
Will publish more interesting design when there is time .